Other languages:
Just a note for those new to blacksmithing... i tried to follow this guide but had no luck as i was changing the force level then selecting a tool. When you change the tool the force level is reset. Dont make my mistake :p Choose the tool then the force level and this guide makes it so easy to get high quality blades. First attempt i made after discovering my previous mistake i got a blade level 7134..thanks Lollipop - Cilvekus
Start with a shaping mallet and force 8. Hammer allong the front edge taking 8 hits (be careful not to miss the last hit).
Switch to the chisel and force 9. Hit the two front conerns.
Next hit the front edge one unit in from where it slopes steeply.
Switch to force 4 and rotate your camera.
Hit the 3 red dots, then switch to the ball peen hammer and force 9 and strike the two blue dots.
This part is hard. First hit the two spots on the very back edge which are next to the lowest point on the goal.
Then hit the points one row towards the front of the blade.
Finally you want to hit the points on the back edge of the project which are shown as the lowest points in the goal. However you can't actually hit them from this angle.
Rotate your camera again, and hit these two points.
Fin.
